One is to be familiar with the route of the construction site, because the transportation distance of asphalt directly affects the quality of asphalt, so when building an asphalt soil mixing plant, comprehensive consideration must be given to fully meet the needs of the site. The distribution of asphalt should be fully confirmed according to the construction drawings to facilitate the positioning of the approximate center of the asphalt mixing plant.

Because the bitumen concrete processed by modified bitumen plants has been widely accepted by the society, modified bitumen plants is also welcomed by the market. After the machinery has been used for a period of time, such problems will always occur. How to deal with the situation that the modified bitumen plant is blocked from dropping the modified material. The modified bitumen plant is a typical polymer material, which is very sensitive to the change of ambient temperature. However, after the operation of the modified bitumen plants, the temperature in the melting tank is above 180℃, which is easy to cause the modified bitumen plant to adhere to the drop chute above the spiral feeding device, and the modified asphalt storage tank will cause the accumulated modified material to drop.

1. What materials are used for rubber bitumen storage tanks
Rubber asphalt storage tank is an important main purpose in paving roads. The materials of many equipment determine its service life, grade and application conditions. Therefore, suitable materials will increase the service life of the rubber bitumen storage tanks! So what materials should be used for rubber bitumen storage tanks?

In the process of asphalt mixing plant, heating is one of the indispensable links, so the heating system must be set up in the asphalt mixing station. This system will fail under the influence of various factors, which means that the heating system must be modified.

Asphalt mixing plants are one of the most important equipment for producing asphalt products. If it fails, the output of the product will inevitably decrease. This is a heavy burden worthy of attention, so what problems often occur in asphalt mixing plants?

In the application, the asphalt spreader has intelligent asphalt spreading rate and low investment, low power consumption, low cost, high thermal efficiency. The asphalt spreader can achieve the temperature required for construction in a short time. It is easy to use and move. It can be operated by one person. A single set of electric heaters is a bit expensive. In the production process of the asphalt spreader, water, as a production material, needs to be heated from room temperature to about 55°C. The evaporation heat of the asphalt spreader is transferred to the drainage. It was found that after the emulsified asphalt was produced for 5 tons, the asphalt spreader was accompanied by a significant increase in the temperature of the cooling circulating water. The production water uses cooling circulating water, and the water basically does not need to be heated. It can save 1/2 of the fuel simply from the energy.