Regularly test the electrical equipment connector resistors and lightning protection equipment connector resistors of bitumen decanter equipment. When installing lightning protection equipment for bitumen decanter equipment, attention should be paid to burying the hot-dip galvanized flat iron in the wet ash compaction pile, and then select 3 points, bury 6 flat irons at each point, and connect the bitumen de-barreling equipment with flat irons in the middle to form a 2~4 square meter grounding network. The lightning protection grounding position should be around 4m from the mixing building, so that it can be lightning-proof instead of attracting lightning.

When using emulsified bitumen equipment, it should be noted that the longer the storage period of the bitumen in the emulsified bitumen equipment is, the greater the deposits caused by air oxidation, and the more serious the direct impact on the quality of the bitumen. Therefore, when using emulsified bitumen equipment, the bottom of the tank must be checked once a year to determine whether the emulsified bitumen equipment needs to be cleaned.

The asphalt mixing plant is mainly determined based on the actual situation of the construction site, so that it can meet the production needs and give full play to the effectiveness of the mixing plant. Of course, the selection of asphalt mixing plants is bound to be not that simple, and there are many factors that need to be considered, which are mainly reflected in the following aspects.

First of all, the selection of the delivery pump in the asphalt mixing station must meet the requirements of the maximum asphalt pouring time per unit time during construction, the higher height, and the larger horizontal distance. At the same time, there must be a certain amount of technical and production capacity reserves, and the balanced production capacity is preferably 1.2 to 1.5 times.

Asphalt tanks are widely used in the field of construction roads, which brings great convenience to workers, but do you know how asphalt tanks are made? Let's take a look at it together.
1. When making and designing, it is necessary to pay attention to minimize the problem of too much residual asphalt at the bottom and the inability to remove it completely, and try to make the asphalt residue in normal use less than one centimeter, which can also reduce the consumption level.

After the asphalt spreader has been used for a period of time, many stains will be generated around the equipment. If it is not cleaned for a long time, a thick layer will be formed, which is more difficult to clean. Although the cleaning methods are all known, we need to pay attention to some asphalt spreader issues when cleaning the construction.